Action Figure

As a family of collectors we know the pain of having a figure with loose joints. You know - those ankles that give with minimal weight. Those ab crunches that refuse to hold for your favorite pose, and let's not forget those ball joints that are too loose to hold the figure's head up. We've experienced the pain.

In our journey to try the best "fix" we tried many different methods and we've finally found the solution.

This compound is not too thick and not too thin, but just right to get into those tight crevices on all figures. The needle bottle allows you to access those hard to reach areas with ease,  that we can't with a q-tip or paper towels. I hope you give this a try. I'm offering a money back guarantee to the first 100 customers. Try it risk free.

HOW TO USE:

Apply a small amount to joints one drop at a time. There's no need to saturate the joint too much.

Move the joint back and forth allowing the solution to penatrate deep into the joint. This is very important.

Wipe Excess solution off with a cloth.

Let the compound dry for at least four hours. Bottle Says 2 but the longer the better. For better results I recommend 24 hours. For head Joints Allow to dry 24 hours.

Test the joint and repeat as needed.

(SOME PLASTICS TAKE LONGER TO DRY)

Clean excess with a damp cloth.

Stored at room temperature.